eaton fuller automatic transmission problems

#Eaton fuller automatic transmission problems manual#

Replace this with new ATF-approved Eaton Fuller automatic transmission fluid refer to your owner’s manual for correct type and quantity requirements.Step 2: Use an oil extraction pump to remove all of the fluid from the transmission, making sure not to spill any on your clothes or skin as it is toxic when ingested or touched Locate the transmission dipstick and remove it from its holder.

Apply the parking brake for additional safety.Step 1: Park the truck on a flat surface and turn off the engine.Lastly turn off ignition switch for few seconds and restart it making sure no trouble codes appear when you get it into drive mode or any other gear position if everything checks out ok then resetting process of Eaton Fuller Automatic Transmission has been done successfully! Now start up your engine while keeping your foot firmly on the service brakes and wait until you hear two audible clicks (indicating that fuel valve has been activated) then release your foot from service brakes slowly after hearing these two clicks indicating that shifter calibration has been completed successfully. Turn on the ignition switch but do not start the engine yet, then move shift selector through all gears including reverse several times quickly before returning it back to neutral again.Ĥ. Put the transmission in neutral and turn off all electrical power to the transmission for at least a minute.ģ. To reset an Eaton Fuller Automatic Transmission, first make sure the vehicle is parked on level ground and that the parking brake is engaged.Ģ.

Eaton fuller automatic transmission problems